The ADR 1000-point calculation determines how many dangerous goods as small packages may be transported in a single transport unit using the partial exemption from ADR 1.1.3.6. By multiplying the quantity of dangerous goods by a set factor, it is calculated whether the load remains within the 1000-point limit.
This scheme is important for transport companies, own drivers and shippers. When the calculated value is not higher than 1000 points, certain ADR obligations lapse, such as the requirement to have an ADR driver certificate and to display orange plates for this transport. Other regulations, however, remain applicable.
What is the ADR 1000-point scheme?
The 1000-point scheme is set out in ADR 1.1.3.6 and applies to the transport of dangerous goods in packaging, such as boxes, jerrycans, drums, gas bottles and IBCs. The scheme is intended solely for the transport of small packages and cannot be applied to tank transport or bulk transport. The name 1000-point scheme does not mean that a maximum of 1000 kilograms or 1000 liters of dangerous goods may always be transported. The allowed quantity depends on the transport category in which the dangerous goods are classified.
Each ADR entry has a transport category for this. You can find it in column 15 of table A in chapter 3.2 of the ADR.
Which transport categories and multiplication factors apply?
ADR distinguishes five transport categories. For each category a maximum quantity per transport unit applies.
| Transport category | Maximum quantity* | Multiplication factor |
|---|---|---|
| 0 | No exemption possible | Not applicable |
| 1 | 20 kg/liter | × 50 |
| 2 | 333 kg/liter | × 3 |
| 3 | 1000 kg/liter | × 1 |
| 4 | Unlimited within ADR 1.1.3.6 | × 0 |
The unit depends on the type of dangerous goods. For certain UN numbers in transport category 1 a different maximum quantity of 50 and a multiplication factor of 20 apply.
Dangerous goods from transport category 0 cannot be transported under this exemption. Goods from transport category 4 are not counted in the calculation, but must still be handled according to the applicable regulations.
How do you calculate the number of ADR points?
When only dangerous goods from one transport category are transported, you can compare the relevant quantity with the maximum quantity in the table.
For a combined load with different transport categories, the total must be calculated according to ADR 1.1.3.6.4.
The calculation consists of three steps:
- Determine the transport category of each dangerous good based on the correct ADR entry and column 15 of table A.
- Determine the quantity in the prescribed unit and multiply it by the factor associated with the transport category.
- Add the calculated values together. The total must not exceed 1000 points.
A calculated value of exactly 1000 points is allowed. For a value above 1000 the exemption cannot be applied to that load as a whole.
Example calculation: different dangerous goods in one truck
A transport company transports the following dangerous goods:
- 100 liters of a liquid from transport category 2.
- 200 liters of a liquid from transport category 3.
The calculation is as follows:
| Transport category | Quantity | Factor | Points |
|---|---|---|---|
| 2 | 100 liters | × 3 | 300 |
| 3 | 200 liters | × 1 | 200 |
| Total | 500 |
The total value amounts to 500 points. The truck therefore remains within the 1000-point limit and may, provided all other conditions are met, make use of ADR 1.1.3.6.
If the same truck were to also carry 200 liters of a liquid from transport category 2, 600 points would be added. The total would then be 1100 points. The exemption cannot be used for the combined load in that case.
Which quantities should you use for the 1000-point calculation?
A common mistake is that the 1000-point calculation is done exclusively with kilograms. However, the ADR specifies different units.
For liquids, the amount of hazardous liquid is measured in liters. For solids and, among others, liquefied gases, the net mass in kilograms is used.
For compressed and adsorbed gases, the water content of the container in liters is decisive. For objects, the mass of the objects without packaging is generally used. For explosive items of class 1, the net mass of the explosive substance is applied.
This distinction is important. A gas cylinder with a water content of 50 liters, for example, is not calculated in the same way as a tank with 50 liters of combustible liquid.
The prescribed unit and transport category must therefore be determined for each substance or each object individually.
Which ADR obligations remain applicable under 1000 points?
The 1000-point scheme is a partial exemption. Even when the load remains within the allowed limit, various ADR regulations must still be complied with.
Thus, among other things, the applicable requirements remain in force for:
- Approved packaging and the correct marking and labeling.
- A correct ADR transport document, including the required quantity data per transport category.
- Instruction and training of involved personnel according to ADR 1.3.
- The safe loading, securing and handling of hazardous goods.
- The prescribed fire‑extinguishing equipment, including the applicable minimum requirement of a portable 2 kg fire extinguisher for the motor vehicle.
- The prohibition of smoking and other relevant operational safety regulations.
For transport under ADR 1.1.3.6 an ADR driver certificate is not required for this transport. However, the driver must have received the required training and instruction for his duties.
ADR safety advisor needed for your transport activities?
When your company transports hazardous goods and does not fall under an applicable exemption, it may be mandatory to appoint an ADR safety advisor.
ADR Advisors provides external services for independent drivers and small transport companies, including a digital ADR annual report. View our services here.
